Epson PowerLite 50c User Manual - Page 30

What To Do If You See a Blank Screen, projector to sync up after pressing the button.

Get Epson PowerLite 50c PDF manuals and user guides View all Epson PowerLite 50c manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

What To Do If You See a Blank Screen If you see a blank screen or a blue screen with the message No Signal after turning on your computer or video source, do one of the following: s Make sure the cables are connected correctly, as described in Chapter 1. s Make sure the Power light is green and not flashing and the lens cap is off. s If you've connected more than one input source, you may need to press the Source button on top of the projector or the Computer, Video, or S-Video button on the remote control to select the source you want to use. (Allow a few seconds for the projector to sync up after pressing the button.) Source button Computer, Video, and S-Video buttons s Try restarting your computer. s If you still don't see an image and you're using a PowerBook, see page 26 for additional steps. If you're using a PC laptop, see page 27. Using the Projector 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
Using the Projector
25
What To Do If You See a Blank Screen
If you see a blank screen or a blue screen with the message
No Signal
after turning on your computer or video source, do one of the
following:
■
Make sure the cables are connected correctly, as described in
Chapter 1.
■
Make sure the
Power
light is green and not flashing and the
lens cap is off.
■
If you
’
ve connected more than one input source, you may need to
press the
Source
button on top of the projector or the
Computer
,
Video
, or
S-Video
button on the remote control to
select the source you want to use. (Allow a few seconds for the
projector to sync up after pressing the button.)
■
Try restarting your computer.
■
If you still don
’
t see an image and you
’
re using a PowerBook, see
page 26 for additional steps. If you
’
re using a PC laptop, see
page 27.
Source button
Computer,
Video, and
S-Video
buttons