HP DesignJet Z6 User Guide - Page 117
Device and Document Settings, Custom Properties, Paper/Quality, Paper, Settings
View all HP DesignJet Z6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
6. Select the Device and Document Settings tab, and click the Custom Properties button. 7. In the Paper/Quality or Paper tab (depending on the driver version), select the paper type that you intend to use. NOTE: If you select neither the paper source nor the paper type, the printer will not print on any protected roll (see Protect a paper type on page 73). 8. Select the print quality (your own choice between speed and quality of printing). 9. If you intend to print on roll paper, you must decide where the printer should cut the paper. ● With the Windows V3 driver: Select the Paper/Quality tab, then click the Margins/Cutter Settings button, then Clip content by margins. ● With the Windows V4 driver: Select the Layout tab, then in the Layout Mode area click With margins > Clip content by margins. You can also adjust the crop lines, which indicate where to cut the paper after printing. See Print with crop lines on page 69. If you have a Z6dr or Z9+dr, you can enable the vertical trimmer and cut the left and right edges of the paper. ENWW Print a project 109