HP DesignJet Z6 User Guide - Page 24
Con your printer, Connect the printer to your network, Modify network configuration
View all HP DesignJet Z6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
To print a demo print, tap , then scroll down and tap Internal prints, then Demo prints, and select a print. The following prints are available: ● Render ● CAD black & white ● GIS Configure your printer Connect the printer to your network The printer is able to configure itself automatically for most networks, in a similar way to any computer in the same network. The first time you connect it to a network, this process may take a few minutes. Once the printer has a working network configuration, you can check its network address from the front panel: tap . TIP: Consider making a note of the printer's IP address, because you may need it during the setup process of connecting your Windows or macOS computer clients. Modify network configuration To modify the current network configuration, go to the front panel and tap , then , then Network > Gigabit Ethernet. From here it is possible, though not normally necessary, to change the settings manually; this can also be done remotely using the Embedded Web Server. For full details of the available connectivity settings, see Networking on page 51. If you accidentally misconfigure the printer's network settings, you can restore the network settings to their factory values from the front panel: tap , then Network > Restore factory settings. Then you must restart the printer. This automatically provides a working network configuration for most networks. The printer's other settings remain unchanged. Install your printer under Windows The following instructions apply if you intend to print from software applications using a printer driver. See Printing on page 59 for alternative ways of printing. 16 Chapter 1 Introduction ENWW