HP DesignJet Z6 User Guide - Page 166
Vertical trimmer does not cut accurately (Z6dr and Z9+dr only), Automatic calibration, WARNING
View all HP DesignJet Z6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 166 highlights
6. Confirm that the modules are positioned correctly, then close the window. 7. Turn on the printer The vertical trimmer is a Customer Self-Repair part. If the blade has had too much use, you can order a replacement. Contact HP Support for more information: see Contact HP Support on page 193. Vertical trimmer does not cut accurately (Z6dr and Z9+dr only) If the vertical trimmer does not cut the right and left edges of the paper accurately, you may need to calibrate the cutter. To check the status of the vertical trimmer modules, go to the front panel, tap , then Output options, then click the vertical trimmer card. The global status of the cutter and modules is displayed. If the status is Calibration pending, you should recalibrate the cutters. Automatic calibration 1. From the front panel, tap , then Output options, then click the vertical trimmer card; tap , and then Calibrate automatically. 2. The printer automatically recalibrates the vertical trimmer modules, advances the paper, and cuts the paper several times. Follow the instructions on the front panel. The printer may prompt you to remove the paper from the platen. WARNING! Do not insert your hands inside the print and cutting area. If you are satisfied with the calibration, you can reprint your print. 158 Chapter 14 Troubleshooting paper issues ENWW