HP DesignJet Z6 User Guide - Page 49
The following steps assume that you have decided to attach immediately. If you decide to attach later
View all HP DesignJet Z6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
NOTE: If you decide to use the take-up reel during printing, familiarize yourself with the procedural steps before tapping the Enable button. Attaching the take-up reel during printing requires you to complete the procedure while the printer is feeding and printing paper. Attaching the take-up reel during printing saves approximately 1.5 m (4.9 ft) of paper. TIP: You are recommended to keep the take-up reel winding-direction switch in the off position (see Unload the take-up reel on page 47) to avoid unwanted movements when attaching the take-up reel while printing. Once you have the leading edge of the paper attached to the core, and the paper is straight, switch the winding-direction switch to position 1 or 2, as you prefer. Setting 1 winds the paper so that the printed image faces in, setting 2 winds the paper so that the printed image faces out. The following steps assume that you have decided to attach immediately. If you decide to attach later, during printing, you must complete the same operations without guidance from the front panel. 2. Remove the tension bar. 3. Unlock the take-up reel by pushing its lever to the highest position. 4. Remove the take-up reel. ENWW Use the take-up reel 41