HP DesignJet Z6 User Guide - Page 163
Strip stays on the output tray and generates jams
View all HP DesignJet Z6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
9. Turn on the printer. 10. Reload the roll, or load a new sheet see Paper handling on page 25. NOTE: If you find that there is still some paper causing an obstruction within the printer, restart the procedure and carefully remove all pieces of paper. Strip stays on the output tray and generates jams If a small piece of paper (200 mm or smaller) has been cut, such as before (if new roll) and after a full-bleed print or after the front-panel option Form feed and cut has been used, the cut strip remains in the output tray. Only when the printer is not printing, reach into the tray and remove the strip. Strip stays in the output area and cutter rail area and generates jams (Z6dr and Z9+dr only) 1. Turn off the printer. 2. Open the printer window and vertical trimmer window, and remove the strips of paper. Printer displays out of paper when paper is available If the roll has become loose from its core, it will not feed correctly and the printer will not load the paper. If possible, tighten the paper to its core or load a new roll. Prints do not fall neatly into the basket ● Ensure that the basket is correctly installed. ● Ensure that the basket is open. ENWW Strip stays on the output tray and generates jams 155