HP DesignJet Z6 User Guide - Page 167
Vertical trimmer: printer reports missing modules (Z6dr and Z9+dr only), Manual calibration, WARNING
View all HP DesignJet Z6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
Manual calibration If you would like to fine-tune the calibration of the modules, you can calibrate the left and right modules manually. 1. From the front panel, tap , then Output options, then click the vertical trimmer card; tap , and then Adjust trimmer modules manually. 2. Use the buttons to move the left and right modules. 3. If you are satisfied with the recalibration, tap to return to the home page, and reprint your job. If you are not satisfied with the manual calibration, tap at the top of the window, then Restore values. Returning to the default calibration sets all the corrections made by the manual calibration to zero. Vertical trimmer: printer reports missing modules (Z6dr and Z9+dr only) If the printer reports that there are missing modules: 1. At the front panel, tap , then Output options, then on the Vertical trimmer card tap Replace. 2. When prompted by the front panel, open the vertical trimmer window. WARNING! Do not insert your hands into the carriage. 3. To put a module back in place, pinch the latch and insert it into the cutter support. NOTE: There is only one way to insert the modules. NOTE: The cut-away blue part connects to the black plastic support in only one way. ENWW Vertical trimmer: printer reports missing modules (Z6dr and Z9+dr only) 159