HP DesignJet Z6 User Guide - Page 40
Roll out of paper procedure, Manual unload procedure, Load a single sheet
View all HP DesignJet Z6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
1. Tap , then the roll icon, then Unload. 2. You may need to open the roll cover. 3. If the roll is uncuttable, see Manual unload procedure on page 32. Roll out of paper procedure If the end of the paper is no longer attached to the core, pull out the paper from the printer. Pull from wherever the paper is accessible; the rear of the printer is recommended. You may need to open the roll cover. Manual unload procedure Paper types that cannot be cut by the automatic cutter must be unloaded manually: 1. Open the roll cover. 2. If necessary, rewind the paper by turning the spindle manually, until the paper is removed from the printer. 3. Close the roll cover. Load a single sheet Z9+ single-roll models have an input tray at the rear of the printer, and the front panel will recommend using this path to load the sheet. However, if you prefer, you can use the cut-sheet slot on the top of the printer. If there is no input tray, you must use the cut-sheet slot on the top. Cut-sheet slot at the top Input tray at the rear Using the cut-sheet slot at the top 1. Ensure that all roll covers are closed. If any cover is opened while a sheet is loaded, the sheet will be immediately unloaded. 2. On the front panel, tap , then Sheet > Load. 3. Select your paper category and type. TIP: If you have loaded a paper type whose name does not appear in the paper list, see Paper type is not in the driver, HP Utility, or front panel on page 149. 32 Chapter 2 Paper handling ENWW