HP DesignJet Z6 User Guide - Page 47

CAUTION: Remove the cut piece from the output tray. If strips or short prints are left in the output tray the printer could jam. NOTE: Photo and coated paper requires careful handling, see Print is scuffed or scratched on page 166. TIP: To move the paper without cutting it, see Move the paper on page 38. Maintain paper To maintain paper quality, follow the recommendations below: ● Store rolls covered by another piece of paper or cloth ● Store cut sheets covered and clean or brush them before loading them in the printer ● Clean input and output platens ● Always keep the window of your printer closed NOTE: Photo and coated paper requires careful handling, see Print is scuffed or scratched on page 166. Change the drying time You may wish to change the drying time setting to suit special printing conditions such as multiple prints where time is of higher importance or when you need to be sure ink is dry before handling. Tap , then Default printing configuration > Print retrieval > Drying time. You can select: ● Extended, to set a longer than recommended time to ensure ink is completely dry ● Optimal, to set the default and recommended time for your selected paper (this is the default setting) ● Reduced, to set a shorter than recommended time when quality is of lower importance ● None, to disable the drying time and remove your print as soon as it finishes printing CAUTION: If the ink is not dry when the print is removed it could leave ink in the output tray and marks on the print. NOTE: If you cancel the drying time during a print, the printer may not feed and cut the paper right away due to the printhead maintenance, which runs in parallel. If the dry time is zero, the printer cuts the paper and then performs the printhead maintenance. However, if the dry time is greater than zero, the printer does not cut the paper until after the printhead maintenance has completed. ENWW Maintain paper 39