HP DesignJet Z6 User Guide - Page 169
Recalibrating the paper advance procedure, Return to default calibration, If you would like
![]() |
View all HP DesignJet Z6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 169 highlights
Recalibrating the paper advance procedure CAUTION: If you are using a transparent paper or film, go directly to step 3 of this procedure. 1. From the front panel, tap , then Paper advance calibration > Paper advance calibration. The printer automatically recalibrates the paper advance and prints a paper advance calibration image. 2. Wait until the front panel displays the status page, and reprint your print. NOTE: The recalibration procedure takes approximately three minutes. Do not worry about the paper advance calibration image. The front-panel display shows any errors in the process. If you are satisfied with your print continue using this calibration for your paper type. If you see improvement in your print, continue with step three. If you are dissatisfied with the recalibration, return to the default calibration, see Return to default calibration on page 161. 3. If you would like to fine-tune the calibration or are using a transparent paper, tap , then Paper advance calibration > Adjust paper advance. 4. Select the percentage of change from -100% to +100%. To correct light banding, decrease the percentage. To correct dark banding, increase the percentage. 5. Tap on the front panel to return to the all-apps page. Return to default calibration Returning to the default calibration sets all the corrections made by the paper advance calibration to zero. To return to the default paper advance calibration value, you must reset the calibration. ENWW Recalibrate the paper advance 161
![](/manual_guide/products/hewlettpackard-designjet-z6-user-guide-893aa00/169.png)