HP Disk System 2300 HP StorageWorks Disk System 2300 User's Guide(This manual - Page 43
Auto-Termination, For other HBAs, check the documentation for your particular host bus
View all HP Disk System 2300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Auto-Termination Auto-termination is disabled when a shunt is installed over both pins on the TP2 pinset. To enable auto-termination, remove the shunt entirely or move it to only one of the pins. The result must be open pins, as shown in Figure 14. Verify that auto-termination is enabled on the host system. For other HBAs, check the documentation for your particular host bus adapter. Installation Installation 43
Installation
43
Installation
Auto-Termination
Auto-termination is disabled when a shunt is installed over both pins on
the TP2 pinset. To enable auto-termination, remove the shunt entirely or
move it to only one of the pins. The result must be open pins, as shown
in
Figure 14
. Verify that auto-termination is enabled on the host system.
For other HBAs, check the documentation for your particular host bus
adapter.