HP Disk System 2300 HP StorageWorks Disk System 2300 User's Guide(This manual - Page 71
Step 4: Install BCCs, into the the left slot at the back of the disk system. Stop pushing when
View all HP Disk System 2300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Installation Step 4: Install BCCs The disk system comes with one or two BCCs, depending on the option purchased. If you are installing only one BCC, you will install a BCC filler in the open BCC slot. 1. Attach your ESD strap to ground. 2. Unpack the BCC from the accessories box and ESD bag. WARNING Do not touch the pins on the back of the BCC. 3. Loosen the locking screws (D in Figure 41) if necessary on the BCC cam latches. 4. Open the BCC cam latches (C in Figure 41) by pulling them away from the center. 5. Align the BCC alignment guides (E) with the slot, and insert the BCC into the the left slot at the back of the disk system. Stop pushing when the BCC meets the midplane. 6. Press the cam latches inward and flat against the center. The cam action draws the BCC completely into the slot and seats the connector pins on the midplane. 7. Tighten the locking screw (D). Installation 71