HP LH4r HP Netserver LH 3/r and LH 4/r Mass Storage Kit - Page 10

Chapter 1 Introduction CAUTION An insulating sheet covers the cage's management board and backplane. Leave it in place, and be careful not to damage it. Tools You Need The following materials are also required to install this upgrade: • Antistatic Service Kit (3M® part number 8501/8502/8505 or equivalent) containing a wrist strap, antistatic mat, and cable. Use this kit to prevent damage to the system from static electricity. • T-15 Torx driver • T-25 Torx driver • HP NetServer Navigator CD-ROM (required for RAID configuration) Documents You May Need Refer to the following documents supplied with your NetServer: • User guide: the HP NetServer LH 3/LH 3r User Guide or the HP NetServer LH 4/LH 4r User Guide • Road map: the HP NetServer LH 3 Installation Road Map, the HP NetServer LH 3r Installation Road Map, the HP NetServer LH 4 Installation Road Map, or the HP NetServer LH 4r Installation Road Map • Integrated HP NetRAID Controller Configuration Guide The HP NetServer Ultra2 SCSI Hot-swap Hard Disk Drive and Tray User Guide is supplied with accessory Ultra2 SCSI hot-swap hard disk drives and trays. If you have a NetServer installed in a rack, refer to either the Rack Cabling Reference for the HP NetServer LH 3r, or to the HP NetServer LH 4r Rack Cabling Reference, and to the appropriate reference listed below: • For an HP Systems rack: Appendix A of the HP NetServer LH 3/LH 3r User Guide or the HP NetServer LH 4/LH 4r User Guide • For an HP Rack System/E rack or HP Rack System/U rack: Chapter 8 of the HP NetServer LH34/LH 3r User Guide or the HP NetServer LH 4/LH 4r User Guide • For a Compaq rack: HP NetServer LH 3r Installation Guide for Compaq® 4000/7000 Racks or HP NetServer LH 4r Installation Guide for Compaq® 4000/7000 Racks The HP NetServer Online Documentation CD-ROM contains all of the documents listed above. 6