HP LH4r HP Netserver LH 3/r and LH 4/r Mass Storage Kit - Page 25
Step 5, Remove Fan Assemblies
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 2 Installation 5. Insert six screws into the front of the hot-swap mass storage cage, as shown in Figure 2-12, and tighten them. Step 5: Remove Fan Assemblies Before you install the SCSI cable, remove two fan assemblies to gain working space and access to the SCSI B connector on the I/O board. The fan assemblies are the same in the pedestal and rack configurations of the NetServer, but separate instructions are supplied because the NetServers are oriented differently. To remove the fan assemblies, follow the procedure for your NetServer configuration: • HP NetServer in pedestal configuration • HP NetServer in a rack For a Pedestal NetServer Do the following to remove the fan assemblies from an HP NetServer in pedestal configuration: 1. Disconnect the fan cables from the Fan 0 and Fan 1 connectors, shown in Figure 2-13, on the system backplane. 21