HP LH4r HP Netserver LH 3/r and LH 4/r Mass Storage Kit - Page 15
Remove two screws securing the bezel latch assembly to the rack,
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Chapter 2 Installation Figure 2-3. Remove Front Bezel from NetServer in HP Rack 5. Unscrew the NetServer chassis from the front of the HP rack, as follows: a. Remove two screws securing the bezel hinge to the rack, as shown in Figures 2-4 and 2-5. Do not unscrew the entire hinge from the chassis; remove only the outer screws, so the hinge remains attached to the NetServer chassis. b. Remove two screws securing the bezel latch assembly to the rack, as shown in Figures 2-4 and 2-5. Do not unscrew the entire assembly from the chassis; remove only the outer screws, so the latch assembly remains attached to the NetServer chassis. 11
Chapter 2
Installation
11
Figure 2-3. Remove Front Bezel from NetServer in HP Rack
5.
Unscrew the NetServer chassis from the front of the HP rack, as follows:
a.
Remove two screws securing the bezel hinge to the rack, as shown in
Figures 2-4 and 2-5. Do not unscrew the entire hinge from the chassis;
remove only the outer screws, so the hinge remains attached to the
NetServer chassis.
b.
Remove two screws securing the bezel latch assembly to the rack, as
shown in Figures 2-4 and 2-5. Do not unscrew the entire assembly from
the chassis; remove only the outer screws, so the latch assembly
remains attached to the NetServer chassis.