HP LH4r HP Netserver LH 3/r and LH 4/r Mass Storage Kit - Page 29
Attach SCSI Cable Connector, Attach SCSI Cable Connector to Cage's
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Chapter 2 Installation To attach the 68-pin connector, press on the center of the connector strain relief and press the connector into place, as shown in Figure 2-16. Two clicks indicates the connector is properly installed. Figure 2-16. Attach SCSI Cable Connector 3. Connect the SCSI cable's 68-pin connector labeled "To SCSI Mass Storage Device" to the SCSI connector on the cage's backplane, as shown in Figure 2-17. SCSI Connector on Cage's Backplane Connector Labeled "To SCSI Mass Storage Device" SCSI Cable Figure 2-17. Attach SCSI Cable Connector to Cage's Backplane (Shown Oriented for HP NetServer LH 3 or LH 4) 25
Chapter 2
Installation
25
To attach the 68-pin connector, press on the center of the connector strain
relief and press the connector into place, as shown in Figure 2-16. Two
clicks indicates the connector is properly installed.
Figure 2-16. Attach SCSI Cable Connector
3.
Connect the SCSI cable’s 68-pin connector labeled "To SCSI Mass Storage
Device" to the SCSI connector on the cage’s backplane, as shown in Figure 2-17.
Connector Labeled
"To SCSI Mass
Storage Device"
SCSI Cable
SCSI Connector on Cage’s Backplane
Figure 2-17. Attach SCSI Cable Connector to Cage’s Backplane
(Shown Oriented for HP NetServer LH 3 or LH 4)