HP LH4r HP Netserver LH 3/r and LH 4/r Mass Storage Kit - Page 56
Verify Hard Disk Drive Modules
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Chapter 3 Configure Mass Storage Verify Hard Disk Drive Modules As the HP NetServer restarts, watch the display monitor to determine whether all the drives you installed have been detected. NOTE Any SCSI devices controlled by the integrated HP NetRAID controller will NOT be displayed during the boot process. Any SCSI devices controlled by a SCSI controller without a boot order number will NOT be displayed during the boot process. If no drives in the secondary hot-swap mass storage cage are detected, refer to Chapter 2 as you do the following: 1. Turn off power to the NetServer, and unplug the AC power cord(s). 2. Remove Cover 1. 3. Verify that the power harness is connected correctly to the cage. 4. Verify that the SCSI cable is connected correctly to the cage. 5. Remove the Fan 1 Assembly to verify that the SCSI cable is connected correctly to the SCSI B connector on the I/O board. 6. Replace the Fan 1 Assembly and plug in the Fan 1 cable. 7. Replace Cover 1. 8. Reconnect the AC power cord(s), and restart the NetServer. 9. Watch the display monitor for the boot listing of SCSI devices to determine whether all the drives you installed have been detected. If one drive was not detected, refer to the HP NetServer Ultra2 SCSI Hot-swap Hard Disk Drive and Tray User Guide as you do the following: 1. Determine which drive was not detected. Do this by comparing the SCSI addresses (IDs) of the detected drives with the SCSI addresses in "About SCSI Addresses in Secondary Cage" in Chapter 2 of this guide. (This drive and its module are referred to as "suspect" in the actions below.) 2. Remove the suspect module, and then reinstall it. 3. Restart the NetServer, and see whether the suspect drive is detected. ◊ If the suspect drive is detected, the problem is solved. 52