HP LH4r HP Netserver LH 3/r and LH 4/r Mass Storage Kit - Page 14
Unscrew NetServer from Chassis Retention Bracket, Shown for HP NetServer LH 3r; Number
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Chapter 2 Installation WARNING To prevent the rack from tipping over, extend the anti-tip foot or attach the anti-tip feature before extending the NetServer from the rack. Also lower the leveler feet of the rack to improve stability and to prevent the rack from rolling. Failure to use the anti-tip foot or feature and the leveler feet could result in serious injury. 2. If there is a door on the rack, remove it. 3. The NetServer uses a chassis retention bracket (steel z-bracket) to secure the rear of the NetServer to the rack assembly. Unscrew the NetServer from the chassis retention bracket by removing the two screws shown in Figure 2-2. Leave the bracket attached to the rack column. Remove the Two Screws That Fasten the NetServer to the Chassis Retention Bracket Figure 2-2. Unscrew NetServer from Chassis Retention Bracket (Shown for HP NetServer LH 3r; Number of Power Supply Modules May Vary) 4. Clips attach the front bezel to the NetServer chassis. To remove the bezel, simply pull it toward you until it comes free, as shown in Figure 2-3. 10