HP LH4r HP Netserver LH 3/r and LH 4/r Mass Storage Kit - Page 30

Step 7, Connect Power Harness, Step 8, Replace Fan Assemblies

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Chapter 2 Installation Step 7: Connect Power Harness 1. Orient the P2 power harness connector to the power connector on the backplane of the mass storage cage, as shown in Figure 2-18. SCSI Cable Power Connector on Cage P2 on Power Harness (Latch on Underside) Figure 2-18. Connect Power Harness to Backplane of Mass Storage Cage 2. Connect the P2 on the power harness to the power connector on the backplane of the mass storage cage. Verify that the latch is seated. Step 8: Replace Fan Assemblies The two fan assemblies are identical. Replace them as follows: 1. Insert the prongs of one fan assembly into the Fan 0 holes in the accessory board guide, shown in Figure 2-19. 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
Chapter 2
Installation
26
Step 7:
Connect Power Harness
1.
Orient the P2 power harness connector to the power connector on the
backplane of the mass storage cage, as shown in
Figure 2-18.
P2 on Power Harness
(Latch on Underside)
Power Connector
on Cage
SCSI Cable
Figure 2-18. Connect Power Harness to Backplane of Mass Storage Cage
2.
Connect the P2 on the power harness to the power connector on the
backplane of the mass storage cage. Verify that the latch is seated.
Step 8:
Replace Fan Assemblies
The two fan assemblies are identical. Replace them as follows:
1.
Insert the prongs of one fan assembly into the Fan 0 holes in the accessory
board guide, shown in Figure 2-19.