HP LH4r HP Netserver LH 3/r and LH 4/r Mass Storage Kit - Page 38
chassis retention bracket.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Chapter 2 Installation 7. Push the front bezel into place, so it swings open for access to the hot-swap mass storage cages, as shown in Figure 2-25. Figure 2-25. Push Front Bezel into Place on HP Rack 8. Refer to Figure 2-2, and use two 6x32 screws to secure the NetServer to the chassis retention bracket. 9. If you removed the door of the rack, replace it. 10. Retract the anti-tip foot, if desired. 34
Chapter 2
Installation
34
7.
Push the front bezel into place, so it swings open for access to the hot-swap
mass storage cages, as shown in Figure 2-25.
Figure 2-25. Push Front Bezel into Place on HP Rack
8.
Refer to Figure 2-2, and use two 6x32 screws to secure the NetServer to the
chassis retention bracket.
9.
If you removed the door of the rack, replace it.
10.
Retract the anti-tip foot, if desired.