HP LH4r HP Netserver LH 3/r and LH 4/r Mass Storage Kit - Page 7
default mode.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Chapter 1 Introduction Channel B (Secondary) Non-Hot-Swap SCSI Devices SE Connector I/O Board SCSI B Connector SCSI A Connector Channel B (Secondary) Channel A (Primary) SCSI Cable for Secondary Hot-Swap Mass Storage Cage Secondary Hot-Swap Mass Storage Cage Secondary (SCSI B) Hot-Swap Disk Drives Left Drive Bay (Secondary) Primary (SCSI A) Hot-Swap Disk Drives Right Drive Bay (Primary) Figure 1-2. Secondary Hot-Swap Mass Storage Cage and SCSI Cable Chapter 3 tells how to configure the disk drives in non-RAID configuration (also called "JBOD," or "Just a Bunch of Disks" configuration), which is the factory default mode. Appendix A tells where to find information on configuring the disk drives in RAID configuration under control of the integrated HP NetRAID controller. Appendix B contains warranty and support information, and Appendix C contains regulatory information. 3