HP LH4r HP Netserver LH 3/r and LH 4/r Mass Storage Kit - Page 42

Step 10, Install Hard Disk Drive Modules

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 42 highlights

Chapter 2 Installation 6. Push the front bezel onto the NetServer, as shown in Figure 2-29. Figure 2-29. Push Front Bezel into Place on Compaq Rack 7. If you removed the door of the rack, replace it. Step 10: Install Hard Disk Drive Modules If the secondary hot-swap mass storage cage is locked, unlock it with its key. Refer to the HP NetServer Ultra2 SCSI Hot-swap Hard Disk Drive and Tray User Guide, and install the disk drive modules into the secondary hot-swap mass storage cage. Install all required disk spacers and filler panels. • Remove filler panels from the secondary hot-swap mass storage cage at the positions where you plan to install disk drive modules. • Filler panels must occupy in all empty disk drive locations in the hot-swap mass storage cage. 38

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
Chapter 2
Installation
38
6.
Push the front bezel onto the NetServer, as shown in Figure 2-29.
Figure 2-29. Push Front Bezel into Place on Compaq Rack
7.
If you removed the door of the rack, replace it.
Step 10:
Install Hard Disk Drive Modules
If the secondary hot-swap mass storage cage is locked, unlock it with its key.
Refer to the
HP NetServer Ultra2 SCSI Hot-swap Hard Disk Drive and Tray User
Guide
, and install the disk drive modules into the secondary hot-swap mass
storage cage. Install all required disk spacers and filler panels.
•
Remove filler panels from the secondary hot-swap mass storage cage at the
positions where you plan to install disk drive modules.
•
Filler panels must occupy in all empty disk drive locations in the hot-swap
mass storage cage.