HP LH4r HP Netserver LH 3/r and LH 4/r Mass Storage Kit - Page 51
Con Clear Configuration, drives, View/Add/Delete Configuration, View Disk, Configuration,
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Chapter 3 Configure Mass Storage NOTE The message "Configuration of NVRAM and drives mismatch" indicates that configuration information in the integrated HP NetRAID controller's NVRAM differs from configuration information in hard disk drives. Press any key to start the HP NetRAID Express Tools utility. On the Tools Management Menu, choose Configure, and then do one of the following: • If you do not want RAID on either SCSI A or SCSI B, choose Clear Configuration. • If you want RAID on SCSI A and you want to use the configuration stored on the drives, choose View/Add/Delete Configuration. Then choose View Disk Configuration. To save that configuration to integrated HP NetRAID's NVRAM, press ESC and then choose YES in the Save Configuration? box. • If you want RAID on SCSI A and you want to use the configuration stored integrated HP NetRAID's NVRAM, choose View/Add/Delete Configuration. Then choose View NVRAM Configuration. To save that configuration to the drives, press ESC and then choose YES in the Save Configuration? box. To exit HP NetRAID Express Tools, press ESC repeatedly until the Exit? box appears. Choose YES to exit. Then press CTRL+ALT+DELETE to restart the NetServer. 2. As soon as you see the message Press to enter SETUP on the display monitor, press the F2 function key. NOTE If you wait too long to press the F2 function key, you may not be able to enter the Setup utility, even though the message "Press to enter SETUP" is still displayed. If this happens, restart the NetServer, and press the F2 function key as soon as the message appears. 3. If a power-on password has been set, provide it when prompted. 47