HP LH4r Integrated HP NetRaid Controller Configuration Guide - Page 112
Run View/Add Configuration option of Configuration Utility.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Chapter 11 Troubleshooting No HP NetRAID Adapter Problem: The HP NetRAID BIOS cannot communicate with the firmware on the adapter. Suggested solutions: Remove any HP NetRAID adapters from the PCI slots. If the error message persists, see the Service and Support chapter of the HP NetServer LH 3/LH 3r User Guide. Configuration of NVRAM and drives mismatch Run View/Add Configuration option of Configuration Utility. Press any key to enter the Configuration Utility. Problem: The configuration stored in NVRAM does not match the configuration stored in the drives. All drives contain one set of configuration information, and NVRAM contains a different set. Suggested solution: Do the following to pick the correct configuration from either NVRAM or from the disks. 1. Press any key to enter HP NetRAID Express Tools. 2. From the Configure menu, choose the View/Add Configuration option. View/Add Configuration asks which configuration you want to view: NVRAM or disk. 3. Use View/Add Configuration to examine both configurations. 4. Resolve the configuration mismatch by selecting and saving one of the two configurations. Configuration of NVRAM and drives mismatch for Host Adapter - x Run View/Add Configuration option of Configuration Utility. Press any key to enter the Configuration Utility. Problem: You have installed one or more HP NetRAID-3Si adapters, and the configuration stored in the NVRAM of adapter x does not match the configuration stored in the drives. All drives on that adapter contain one set of configuration information, and NVRAM contains a different set. Suggested solution: Do the following to pick the correct configuration from either NVRAM or from the disks. 1. Press any key to enter HP NetRAID Express Tools. 2. From the Configure menu, choose the View/Add Configuration option. View/Add Configuration asks which configuration you want to view: NVRAM or disk. 106