HP OmniBook 2000 HP OmniBook 2000 - Installation and Setup Guides - Page 31
To install the CD-ROM drive
View all HP OmniBook 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Starting Out with Your OmniBook Using OmniBook Accessories To install the CD-ROM drive You install the CD-ROM drive in the center drive bay of the OmniBook. To use both the CD-ROM drive and the floppy disk drive, connect the floppy disk drive to the OmniBook's parallel port (on the left side of the OmniBook). 1. Important Save your work and shut down Windows-you'll be restarting the OmniBook. 2. If necessary, remove the current accessory module from the OmniBook. 3. Slide the CD-ROM drive into the OmniBook until it clicks into place. 4. Press the square Off button for 2 seconds, then press the blue On/Suspend button to restart the OmniBook. Off button 1-23
Starting Out with Your OmniBook
Using OmniBook
Accessories
1-23
To install the CD-ROM drive
You install the CD-ROM drive in the center drive bay of the OmniBook. To use both
the CD-ROM drive and the floppy disk drive, connect the floppy disk drive to the
OmniBook’s parallel port (on the left side of the OmniBook).
1.
Important
Save your work and shut down Windows—you’ll be restarting the OmniBook.
2. If necessary, remove the current accessory module from the OmniBook.
3. Slide the CD-ROM drive into the OmniBook until it clicks into place.
4. Press the square Off button for 2 seconds, then press the blue On/Suspend
button to restart the OmniBook.
Off button