HP P6300 HP P6300/P6500 EVA Installation Guide (5697-2485, September 2013) - Page 50

Setting the time on the iSCSI or iSCSI/FCoE modules, iSCSI Controller Properties

Get HP P6300 PDF manuals and user guides View all HP P6300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 50 highlights

Figure 38 iSCSI Controller Properties Figure 39 IP Ports Properties Setting the time on the iSCSI or iSCSI/FCoE modules Setting the time is important to synchronize the event logs of the P6000 controllers (1 and 2) with the initiator event logs and to assist in troubleshooting. 1. Select the iSCSI controller in the Navigation pane. 2. Select Set Options, and then select Set time options from the iSCSI Controller Options menu. HP P6000 Command View provides three options for setting the time as shown in Figure 40 (page 51). NOTE: HP recommends using NTP settings if available on your IP network. This can provide redundancy with multiple time servers. 50 Managing the iSCSI or iSCSI/FCoE module using HP P6000 Command View

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
Figure 38 iSCSI Controller Properties
Figure 39 IP Ports Properties
Setting the time on the iSCSI or iSCSI/FCoE modules
Setting the time is important to synchronize the event logs of the P6000 controllers (1 and 2) with
the initiator event logs and to assist in troubleshooting.
1.
Select the iSCSI controller in the Navigation pane.
2.
Select
Set Options
, and then select
Set time options
from the iSCSI Controller Options menu.
HP P6000 Command View provides three options for setting the time as shown in
Figure 40 (page 51)
.
NOTE:
HP recommends using NTP settings if available on your IP network. This can provide
redundancy with multiple time servers.
50
Managing the iSCSI or iSCSI/FCoE module using HP P6000 Command View