HP ProLiant 2500 Compaq ProLiant 2500 Servers Installation Guide - Page 51
Installing Hard Drives in the, Non-Hot-Pluggable Drive Cage
![]() |
View all HP ProLiant 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
3-23 CAUTION: To ensure the hard drive is fully seated in the drive cage slot, the locking hinge of the ejector lever must latch behind the front panel of unit. If this procedure is not followed, the server will not recognize the hard drive. Installing Hard Drives in the Non-Hot-Pluggable Drive Cage To install a non-hot-pluggable hard drive, refer to the installation documentation that came with the drive. The following illustration and steps provide only an overview of this installation. CZR-047.EPS Figure 3-19. Installing Non-Hot-Pluggable Hard Drive 1. Connect the signal and power cables. 2. Set the jumper and SCSI IDs. Compaq ProLiant 2500 Servers Installation Guide
![](/manual_guide/products/hewlettpackard-proliant-2500-compaq-proliant-2500-servers-installation-guide-6355284/51.png)
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
3-23
Compaq ProLiant 2500 Servers Installation Guide
CAUTION:
To ensure the hard drive is fully seated in the drive cage slot, the
locking hinge of the ejector lever must latch behind the front panel of unit. If
this procedure is not followed, the server will not recognize the hard drive.
Installing Hard Drives in the
Non-Hot-Pluggable Drive Cage
To install a non-hot-pluggable hard drive, refer to the installation
documentation that came with the drive. The following illustration and steps
provide only an overview of this installation.
CZR-047.EPS
Figure 3-19.
Installing Non-Hot-Pluggable Hard Drive
1.
Connect the signal and power cables.
2.
Set the jumper and SCSI IDs.