HP T5730 TeemTalk 6.0 for Windows User Manual - Page 197

The General Tab Setup Menus The Start Seq box enables you to enter the character or sequence of characters that initiate a print bypass. The end sequence that terminates the print bypass can be specified either by entering the actual characters in the End Seq box when Specify End Sequence is checked, or by specifying the number of characters that make up the end sequence in the End Length box when End on Non-Hex is checked. If no End Seq is entered, the bypass is assumed to be for a single pair of characters only. If an End Seq is specified, characters in the data stream between the start and end are interpreted as encoded ASCII. For example, "1B0A" becomes ASCII 27 10 (ESC LF). Selecting End on Non-Hex enables you to specify the number of characters that make up the end sequence in the End Length box. The bypass will then terminate as soon as a non-hexadecimal character is received (any character except in the range 0 through 9 and A through F) followed by the end sequence. Characters can be entered in several ways. For example, to specify the ASCII escape character, you can enter either _027, \u001B, \e, \033, or even ^[. IBM 3270 Settings 175