HP T5730 TeemTalk 6.0 for Windows User Manual - Page 253

Setup Menus Transmit Protocol Factory default: ANSI The setting of this option determines whether a partial page of data is transmitted in ANSI or VT131 format when the Send Partial Page option is checked. When ANSI is selected, Local Editing mode will function according to ANSI (American National Standards Institute) rules. When VT131 is selected, Local Editing mode will function in the same way as a VT131 terminal. Select this option when running software written for the VT131. End of Line Characters Factory default: ^M (i.e. CR) This text box is used to specify the characters that are to indicate the end of a line in a data block. To change the current definition, delete the definition displayed in the text box and type in the new one, either as the control key character equivalent or the decimal value of the ASCII character. For example, the default ASCII character CR can be entered by typing the characters ^ and M, representing the keys Ctrl + M which, when pressed together would generate the CR code. Decimal values are entered as three-digit numbers immediately preceded by an underscore character. Values with only two digits must be preceded by a zero. For example, the decimal value of CR is 13, so this would be entered as _013. End of Block Characters Factory default: None This specifies the characters that are to indicate the end of a block of data. To change the current definition, delete the definition displayed in the text box and type in the new one, either as the control key character equivalent or the decimal value of the ASCII character. Block Transmission 231