HP XM600 hp kayak xm600 series 1, troubleshooting guide for minitower models - Page 14

Your PC Workstation Does Not Start Correctly Case 3 - Detected Hardware Configuration Error Symptom... Check that... Symptom... Power-On-Self-Test (POST) displays a memory test error and a Beep code is emitted (1-3-3-1). ERROR ! Memory Error • Memory incorrectly installed. • Memory modules are secured in place with the two retaining clips. • RDRAM module is not installed in the specified socket (furthest from the processor) for the SDRAM Memory Expansion Card. ERROR ! Contin Module ERROR ! No RIMM • RDRAM modules are incorrectly installed in the RIMM sockets. • Missing RDRAM modules. ERROR ! No DIMM Check that... • Continuity modules incorrectly installed or not installed at all. • SDRAM modules are incorrectly installed in the DIMM sockets. • Missing SDRAM modules. Refer to the memory installation table on the following page. Power-On-Self-Test (POST) displays a video test error and a Beep code is emitted (1-2). Symptom... Check that... Video card is: ERROR ! • Present. No Video • Seated correctly in the AGP connector. • Cabled correctly. • Not defective. Possible Cause... • Cables are incorrectly fitted to the corresponding system board connectors. • System board switches incorrectly set. Check that... Cables are correctly connected. If required, refer to the service label inside the cover for the system board layout. Refer to the service label inside the cover for correct settings. Or, refer to "System Board Switches" on page 36. Case 3 - Detected Hardware Configuration Error is continued on the next page ³ 14