HP XM600 hp kayak xm600 series 1, troubleshooting guide for minitower models - Page 34

Clearing the CMOS, Switch on the PC Workstation. Run

Get HP XM600 - Kayak - 128 MB RAM PDF manuals and user guides View all HP XM600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

Configuration Problems Troubleshooting BIOS Problems Clearing the CMOS 1 Turn off the PC Workstation, disconnect the power cord and data cables, then remove the cover. 2 Set the system board switch 8 to the ON position to clear the CMOS memory. 3 Replace the cover, and only reconnect the power cord. 4 Reboot the PC Workstation. A message similar to the following will be displayed: "Configuration has been cleared, set switch Clear to the ON position before rebooting." 5 Turn off the PC Workstation, disconnect the power cord, and remove the cover. 6 Set the system board switch 8 to the OFF position to retain the configuration. 7 Replace the cover, and reconnect the power cord and data cables. 8 Switch on the PC Workstation. Run the Setup program by pressing . Then press , the CMOS default values will be automatically downloaded and saved. 9 Press to save the configuration and exit from the Setup program. 34

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Configuration Problems
Troubleshooting BIOS Problems
34
Clearing the CMOS
1
Turn off the PC Workstation, disconnect the power cord and data
cables, then remove the cover.
2
Set the system board switch
8
to the
ON
position to clear the CMOS
memory.
3
Replace the cover, and only reconnect the power cord.
4
Reboot the PC Workstation. A message similar to the following will
be displayed:
“Configuration has been cleared, set switch Clear to
the ON position before rebooting.”
5
Turn off the PC Workstation, disconnect the power cord, and remove
the cover.
6
Set the system board switch
8
to the
OFF
position to retain the
configuration.
7
Replace the cover, and reconnect the power cord and data cables.
8
Switch on the PC Workstation. Run the
Setup
program by pressing
. Then press
, the CMOS default values will be automatically
downloaded and saved.
9
Press
to save the configuration and exit from the
Setup
program.