HP Z600 HP Z Workstation series User Guide - Page 59

retention clamp is secured by the PCI Card Support.

Get HP Z600 - Workstation - 6 GB RAM PDF manuals and user guides
UPC - 884962074053
View all HP Z600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 59 highlights

To install a PCI or PCIe expansion card: 1. Follow the procedures described in Preparing for component installation on page 40 to prepare the workstation for component installation. 2. Align the card keyway with the slot key, and then firmly seat the card in the slot as shown in the following illustration (1). Figure 8-1 Installing an expansion card 3. Close the retention clamp by rotating it downward (2) as shown in the illustration above. NOTE: For the Z800, close the PCI retention clamp to make sure all cards are seated. The retention clamp is secured by the PCI Card Support. 4. Connect all necessary power and interface cables to the card (follow instructions that came with the expansion card). 5. Replace all components removed in preparation for component installation. ENWW Installing an expansion card 51

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
To install a PCI or PCIe expansion card:
1.
Follow the procedures described in
Preparing for component installation
on page
40
to prepare the
workstation for component installation.
2.
Align the card keyway with the slot key, and then firmly seat the card in the slot as shown in the
following illustration (1).
Figure 8-1
Installing an expansion card
3.
Close the retention clamp by rotating it downward (2) as shown in the illustration above.
NOTE:
For the Z800, close the PCI retention clamp to make sure all cards are seated. The
retention clamp is secured by the PCI Card Support.
4.
Connect all necessary power and interface cables to the card (follow instructions that came with
the expansion card).
5.
Replace all components removed in preparation for component installation.
ENWW
Installing an expansion card
51