HP Z600 HP Z Workstation series User Guide - Page 63
controller to the hard disk drive.
UPC - 884962074053
View all HP Z600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
5. If installing a SAS drive, attach a SAS-to-SATA cable adapter to the connector on the SAS hard drive as shown in the following figure. NOTE: SAS Drives require a separate SAS Controller plug-in card. Figure 9-3 Attaching the cable adapter 6. Push the hard disk drive into the selected bay until it snaps into place (1) as shown in the following figure. Figure 9-4 Installing the HDD drive 7. Attach a power cable (2) to the drive, and attach a data cable (3) from the SATA port or SAS controller to the hard disk drive. NOTE: For SATA and SAS HDDs, connect data cables to lower-numbered drive connectors first on the system board (for SATA HDDs) or SAS controller card (for SAS HDDs). To identify hard disk drive connectors, refer to the workstation service label on the side access panel. ENWW Installing a hard disk drive 55