Icom ID-51A PLUS2 Advanced Owners Manual - Page 212

Previous view 12 MEMORY OPERATION ■■Setting a Memory bank (Continued) DD Directly entering into a memory bank You can also program the memory contents directly into a memory bank channel. This way is a short cut to programming the memory channel, and then assigning it to a bank. In that case, the transceiver automatically selects the lowest blank memory channel, to program. qqPush [V/MHz] to select the VFO mode. wwSet a desired frequency and operating mode: ➥➥Rotate [DIAL] to set a desired frequency. (Example: 146.010 MHz) ➥➥Push [MODE] one or more times to select a desired operating mode. (Example: FM mode) ➥➥Set duplex direction, frequency offset, tone squelch and so on, if desired. eeHold down [S.MW] for 1 second to enter the Select Memory write mode. • 1 short and 1 long beep sound. • The memory channel number blinks, and memory contents are displayed. rrPush [QUICK] to open the Quick Menu screen. ttPush D-pad() to select "Bank Select," and then push D-pad(Ent). D-pad (Ent) () yyRotate [DIAL] to select a desired bank group, "A" to "Z," and then push D-pad(Ent). (Example: "J") • If you want to change the bank group after pushing D-pad(Ent), return to step r. uuRotate [DIAL] to select a desired bank channel between "00" and "99." (Example: "01") • The bank channel number blinks. • If the selected bank channel is already assigned, the memory contents are displayed. iiHold down [S.MW] for 1 second to program, and then return to the VFO mode. • 3 beeps sound. • If an already assigned bank channel is selected in step u, the memory contents will be overwritten into the memory channel and bank channel. • The Bank channel number automatically increases when continuing to hold down [S.MW] after programming. NOTE: Push [CLR] to cancel the program and exit the Select Memory write mode before memory programming. NOTE: If the Memory bank display is already selected and you want to program the contents into the memo- ry channel, do the following steps: q Select "ALL CH Select" in step t. w Rotate [DIAL] to select a de- sired memory channel. e Hold down [S.MW] for 1 second to program. Example: Programming 146.010 MHz/FM mode into Memory bank channel J-01. Hold down [S.MW] for 1 second to enter the Select Memory write mode. Push D-pad() to select "Bank Select." Rotate [DIAL] to select the bank group, "J." The bank channel number blinks. Rotate [DIAL] to select the bank channel "01." Hold down [S.MW] for 1 second to program. Returns to the VFO mode. 12-8