Icom ID-51A PLUS2 Advanced Owners Manual - Page 252
Duplex operation
View all Icom ID-51A PLUS2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 252 highlights
Previous view 15 REPEATER AND DUPLEX OPERATIONS ■■Duplex operation The Duplex operation shifts the transmit frequency up or down from the receive frequency by an offset amount. DDSetting the frequency offset qqPush [V/MHz] to select the VFO mode. wwPush [MENU] . eeP ush D-pad() to select the root item ("DUP/ TONE..."), and then push D-pad(Ent). D-pad (Ent) () rrPush D-pad() to select the "Offset Freq," and then push D-pad(Ent). ttRotate [DIAL] to set the frequency offset to be- tween 0.000.00 and 59.99500 MHz, and then push D-pad(Ent). (Setting example: 1.000.00 MHz) • The selected tuning step in the VFO mode is used when setting the frequency offset. • Pushing [V/MHz] toggles the tuning digit, as shown below. TS* 1 MHz 10 MHz *The frequency changes according to the preset tuning steps. (p. 5-8) yyPush [MENU] to exit the [MENU] screen. [DIAL] To reset to the default value. Push [QUICK] in step t as described above, then push D-pad(Ent) to reset to the default value. NOTE: • The frequency offset cannot be changed while using the DR function. • The Auto repeater function uses the preset frequen- cy offset. Depending on the frequency offset value, the off band indication, "OFF," appears on the display when [PTT] is pushed. (p. 15-5) 15-4 The current frequency offset Rotate [DIAL], then push D-pad(Ent). Push [QUICK] Push D-pad(Ent) The current frequency offset