Icom ID-51A PLUS2 Advanced Owners Manual - Page 214

Previous view 12 MEMORY OPERATION ■■Entering a memory/bank/scan name Each memory channel can be programmed with an alphanumeric channel name for easy recognition. Names can be a maximum of 16 characters. NOTE: Only one name can be programmed for each bank. Therefore, the previously programmed bank name will be displayed when bank name is selected. Also, the bank names are automatically updated in other memory channels assigned to the same bank group. DDEntering a memory name, bank name or scan name qqHold down [S.MW] for 1 second to enter the Select Memory write mode. • 1 short and 1 long beep sounds. • The memory channel number blinks. • DO NOT hold down [S.MW] for more than 2 seconds. wwRotate [DIAL] to select a desired memory channel. • Select Call channels (C0 to C3) to program a Call channel name, or Scan edge channels (0A/0B to 24A/24B) to program a scan name. eePush [QUICK] to open the Quick Menu screen. rrPush D-pad() to select "Edit," and then push D- pad(Ent) to enter the name programming mode. D-pad (Ent) () ttPush D-pad() to select "MNAME," "BNAME" or "SNAME," and then push D-pad(Ent). • MNAME" is for a memory name, "BNAME" for a bank name or "SNAME" for a scan name. • If the selected memory channel's name has already been programmed, the name is displayed. • "BNAME" appears only when the selected memory channel is assigned to a bank. • "SNAME" appears only when the selected memory channel is a scan edge channel. The same name is automatically assigned to both scan edge channels, A and B. • After pushing D-pad(Ent), the cursor blinks on the first digit. NOTE: When entering the scan type selection mode, the programmed Scan name is displayed instead of the frequency range indication. Example: Programming the memory name "ID-51" in M-CH000. In the Select Memory Write mode, select M-CH000, and then push [QUICK] . Push D-pad() to select "Edit," and then push D-pad(Ent). Push D-pad() to select "MNAME." [DIAL] The cursor blinks on the first digit. 12-10 ☞☞Continued on the next page