Icom ID-51A PLUS2 Advanced Owners Manual - Page 390

Previous view 18 OPTIONS ■■VOX function (Continued) DDVOX-related settings The VOX Delay and the VOX time-out timer can be set in the MENU screen. • VOX delay Sets the VOX delay to between 0.5 and 3.0 seconds (in 0.5 seconds steps). The VOX delay is the amount of time the transmitter stays ON after you stop speaking. (Default: 0.5) (MENU > Function > VOX > VOX Delay) TIP: If "VOX" is intermittent, set the VOX delay long enough to allow normal pauses in speech, but return to receive after you finish speaking. • VOX time-out timer Sets the VOX Time-Out Timer to between 1, 2, 3, 4, 5, 10 and 15 minutes to prevent accidental prolonged transmission. To turn OFF the function, select "OFF." (Default: 3) (MENU > Function > VOX > VOX Time-out Timer) TIP: The VOX Time-Out Timer must be set shorter than the transceiver Time-Out Timer, otherwise this timer will not be activated. ■■SJ-1 silicone jacket The SJ-1 silicone jacket can be used when the BP271 battery pack is attached to the transceiver. When the BP-272 battery pack or BP-273 battery case is attached, the jacket cannot be used. TIP: Before attaching or removing the jacket, be sure to disconnect the antenna from the transceiver. To attach: qqPlace the antenna connector and [DIAL] of the transceiver into the holes on the top of the jacket, as shown to the right. wwPull the jacket around the sides and bottom of the transceiver. • When the belt clip is attached, push it out from the hole on back of the jacket. To remove: qqRemove the jacket from bottom of the transceiver. • If a belt clip is attached, pull the jacket around the bottom of the clip. wwPull the antenna connector and [DIAL] from the jacket, and remove it from the transceiver. 18-8