Intel SR1530HCLRNA User Guide - Page 50

AF001614 Figure 19. Installing the Front Bezel (SR1530HCL/SR1530HCLS and SR1530HCLR/SR1530HCLSR) Removing and Installing the Server Cover Removing the Server System Cover The server system must be operated with the server system cover in place to ensure proper cooling. You will need to remove the cover to add or replace components inside of the server. None of the internal components are hot-swappable. Before removing the server system cover, power down the server and unplug all peripheral devices and the AC power cable. Note: A nonskid surface or a stop behind the server system may be needed to prevent the server system from sliding on your work surface. 1. Observe the safety and ESD precautions at the beginning of this book. See "Safety Information" on page iii. 2. Turn off all peripheral devices connected to the server. Turn off the server. 3. Disconnect the AC power cord. 4. (SR1530CL/SR1530CLR) Remove the two screws at the front of the chassis (see letter "A" in the following figure). Loosen the screw at the rear of the chassis (see letter "B"). Push rearward on the blue grip point at the front of the server. Slide the cover back until it stops and then lift the cover upward to remove it.. See letter "C". 28 Server System User Guide