Intel SR1530HCLRNA User Guide - Page 57
Installing and Removing Memory
UPC - 735858197274
View all Intel SR1530HCLRNA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
5. Install the server system cover. For instructions, see "Installing the Server System Cover" on page 30. Installing and Removing Memory Caution: The memory is NOT hot swappable. Before removing or replacing any memory DIMM, you must first take the server out of service, turn off all peripheral devices connected to the system, turn off the system by pressing the power button, and unplug the AC power cord from the system or wall outlet. The silkscreen on the board for the DIMMs displays DIMM A1, DIMM A2, DIMM A3, DIMM B1, DIMM B2, and DIMM B3 starting from the center of the board. See "Memory" on page 15 for a discussion of the memory requirements and options. See "Server System References" on page ix for a link to the list of tested DIMMs. Installing DIMMs To install DIMMs, follow these steps: 1. Observe the safety and ESD precautions at the beginning of this book. See "Safety Information" on page iii. 2. Power down the server and unplug all peripheral devices and the AC power cable. 3. Remove the server system cover. For instructions, see "Removing the Server System Cover" on page 28. 4. Locate the DIMM sockets. See Figure 28. Server System User Guide 35