Intel SR1530HCLRNA User Guide - Page 68

13. Install the server system cover. For instructions, see "Installing the Server System Cover" on page 30. Removing a Hard Disk Drive (SR1530CL/SR1530CLR) 1. Observe the safety and ESD precautions at the beginning of this book. See "Safety Information" on page iii. 2. Power down the server and unplug all peripheral devices and the AC power cable. 3. Remove the server system cover. For instructions, see "Removing the Server System Cover" on page 28. 4. Disconnect the power and data cables from the drive. 5. HDD1 location only: Slide the power cable from the cable clip that is located on the top of the hard drive carrier. 6. Remove the screw that holds the hard drive bracket to the chassis (see letter "A" in the following figure). Save this screw. You will use it later to reinstall the drive assembly. Lift the drive carrier from the chassis (see letter "B"). A B ChFarsosnist AF001050 Figure 40. Removing Drive Carrier from the Server System (SR1530CL/ SR1530CLR) 7. Remove the four screws that attach the hard drive to the drive carrier. Lift the drive from the carrier. Store the drive in an anti-static bag. 8. If you are installing a new drive, skip the rest of these steps and instead see "Installing a Hard Disk Drive (SR1530CL/SR1530CLR)" on page 42, beginning with step 7. 9. Insert the screws that held the drive in the carrier into the screw locations on the carrier for future use. 46 Server System User Guide