Intermec PM4i PM4i Mid-Range Printer User's Manual - Page 113
Adjusting the Label Stop Sensor, black marks. If you are using irregularly shaped labels
View all Intermec PM4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Chapter 4 - Troubleshooting and Maintaining the Printer 2 Loosen the nut that secures the pressure arm. Pressure arm Upper label stop sensor Center of media Edge guide 3 Move the pressure arm inward or outward until the arrow on the tip of the arm is centered with the media. Note: Move the pressure arm at the part closest to the screw, not at the tip. If the arm is difficult to move, lift the printhead and pull the printhead bracket free from the magnet in the arm. 4 When the pressure arm is centered, tighten the nut to secure the arm. 5 Adjust the edge guides. Adjusting the Label Stop Sensor The label stop/black mark sensor (LSS) is a photoelectric sensor that controls the printer's media feed by detecting gaps between labels, or slots or black marks in continuous stock, depending on the printer's media type setup. The LSS must be aligned with the gaps, slots, or black marks. If you are using irregularly shaped labels, align the LSS with the front tips of the labels. PM4i Mid-Range Printer User's Manual 99