Intermec PM4i PM4i Mid-Range Printer User's Manual - Page 143

Appendix A - Specifications Media With RFID Tags or Inlays When printing on RFID media, special consideration must be taken to the position and shape of the tag. Specific recommendations for different kinds of Intermec-approved RFID media can be found on the Intermec website at www.intermec.com. Additional information is provided in the documentation that came with your RFID kit. Accessories for the Printer You can use these accessories (sold and ordered separately) with the PM4i. To order accessories, contact your local Intermec sales representative. Integral Liner Takeup Unit Use this accessory, which comes with a guide shaft, for peel-off (selfstrip) printing. Paper Cutter Use this accessory to cut off continuous paper-based stock or liner between labels. You can collect the cut-off labels, tickets, or tags in an optional tray. If you are running Fingerprint or Direct Protocol, you can control the paper cutter using the commands CUT, CUT ON, and CUT OFF. For help, see the Intermec Fingerprint Command Reference Manual. Media Supply Hub Use the rotating media supply hub for media roll cores with an internal diameter of 38 to 40 mm (1.5 in). Paper Sensor You can use the paper sensor with a rotating media supply hub to detect when the remaining media supply has reached a preset minimum diameter. You can set this diameter in Setup mode. Media Roll Retainer Use the media roll retainer with a rotating media supply hub to keep large media rolls in place. With the media roll retainer installed, you can only use media with a maximum width of 100 mm (3.9 in). PM4i Mid-Range Printer User's Manual 129