Intermec PM4i PM4i Mid-Range Printer User's Manual - Page 126
Be sure to pull at the connectors, not at the cables., Note the snap-lock on the inner connector.
![]() |
View all Intermec PM4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Chapter 4 - Troubleshooting and Maintaining the Printer 2 Turn the printhead lift lever clockwise to raise the printhead. 3 Remove any media and transfer ribbon. 4 Pull the printhead bracket away from the magnet in the pressure arm. 5 Disconnect the printhead bracket from the print mechanism as indicated by the arrows and pull out the printhead as far as the cables allow. 6 Disconnect the cables from the printhead: • Note the snap-lock on the inner connector. • Be sure to pull at the connectors, not at the cables. 7 Connect the two cables to the replacement printhead. 8 Install the printhead. Make sure that the printhead cables run freely. 9 Turn the printhead lift lever counterclockwise so the magnet engages the printhead bracket. 10 Load a new supply of media and ribbon. 112 PM4i Mid-Range Printer User's Manual
![](/manual_guide/products/intermec-pm4i-pm4i-midrange-printer-users-manual-4b45517/126.png)