Invacare SOLARA3G Owners Manual - Page 64
Using/Installing/Adjusting Non-Locking Cantilever Arms, Using Non-Locking Cantilever Arms,
View all Invacare SOLARA3G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
8 ARMS 8.9 Using/Installing/Adjusting Non-Locking Cantilever Arms ƽ WARNING DO NOT use lap trays with non-locking cantilever arms. Using Non-Locking Cantilever Arms 1. Pull the end of the cantilever arm down to lower the cantilever arm. 2. Pull the end of the cantilever arm up to move it out of the way. Installing Non-Locking Cantilever Arms 1. Remove the locknut and washer from the lower hex bolt installed on the non-locking cantilever arm. 2. Slide hex bolt of the cantilever arm assembly into the desired back cane mounting hole. 3. Secure the cantilever arm to the wheelchair with a washer and locknut. 4. Adjust the angle of the cantilever arm, if necessary. Refer to Adjusting Non-Locking Cantilever Arm Angle on page 65. Back Cane Coved Washers and Spacer Cantilever Arm Lower Hex Bolt Back Cane Locknut Washer Cantilever Arm FIGURE 14 Installing Non-Locking Cantilever Arms Adjusting Locking Cantilever Arm Height.. Invacare® Solara®3G/Spree 3G Wheelchair 64 Part No 1154295