Invacare SOLARA3G Owners Manual - Page 86
Adjusting The Quick-Release Axle
![]() |
View all Invacare SOLARA3G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
12 WHEELS/FORKS Rear Wheel Lockwasher Axle Plate Locknut Permanent Axle FIGURE 2 Installing/Removing Rear Wheels - Permanent Axle 12.2 Adjusting The Quick-Release Axle 1. Remove rear wheel and quick-release axle from the wheelchair. Refer to Installing/Removing Rear Wheels on page 84. 2. Depress detent pin in the quick-release axle and slide axle through the wheel hub. 3. Increase or decrease end play in the quick release axle by adjusting the locknut on the end of the quick-release axle. 4. Reinstall rear wheel onto the wheelchair. Refer to Installing/ Removing Rear Wheels on page 84. 5. Release detent pin ensuring that the locking pins are fully released. 6. Repeat STEPS 3-5 until the quick-release axle locks properly. 7. Repeat STEPS 1-6 for opposite side, if necessary. Axle Mounting Plate Locking Pins Quick-Release Axle Wheel Hub (Reference) Rear Wheel (Reference) Locknut Detent Pin Invacare® Solara®3G/Spree 3G Wheelchair FIGURE 12.1 Adjusting The Quick-Release Axle 86 Part No 1154295
![](/manual_guide/products/invacare-solara3g-owners-manual-09b30c5/86.png)