Kenmore HE2t User Guide - Page 25

Adding items You can add items to the washer after the wash cycle has started, if the ADD A GARMENT status light is illuminated. All cycles have this feature except Rinse/Spin and Drain/Spin. To add items 1. Select PAUSE/CANCEL. The washer door unlocks, and items can be added. 2. To continue the cycle, close the door and select and hold START (for approximately 1 second). 3. To unlock the door after the Add a Garment period, press PAUSE/CANCEL twice. This will cancel the Wash Cycle. Cycle Complete The Cycle Complete light stays on for 5 minutes after the cycle is complete. The washer will then power down. Locking controls The Control Lock avoids unintended use of the washer. You can also use the control lock feature to avoid unintended cycle or option changes during a cycle. When CONTROL LOCKED is lit, all buttons are disabled except for PAUSE/CANCEL and START. You can lock the controls while the washer is operating. To lock the controls Select and hold END OF CYCLE SIGNAL for 3 seconds. The CONTROL LOCKED status light illuminates. Estimated Time Remaining The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load. The cycle time will be extended if oversudsing occurs or the load is unbalanced. The SUDs routine removes extra suds and assures proper rinsing of your garments. The options you select will also affect the cycle times that are shown in the Preset Cycle Settings table. The Estimated Time Remaining can change up to 30 minutes under extreme conditions. Door Locked When the status light illuminates, the door is locked. The door is locked and unlocked automatically, depending on the stage of the wash cycle. CYCLES Wash Cycles Choose Wash Cycles by rotating the Cycle selector knob to the desired cycle. The indicator light for the cycle selected will illuminate. Each cycle is designed for different types of fabric and soil levels. To unlock the controls Select and hold END OF CYCLE SIGNAL for 3 seconds until the CONTROL LOCKED Status light turns off. • Each cycle has a preset cycle time, WASH TEMP, SPIN SPEED, and may have preset Options. The preset settings provide the recommended fabric care for the selected cycle. • The preset settings can be changed anytime before START is selected. Not all Options and Modifiers (WASH TEMP, SPIN SPEED) are available with all Cycles. To change settings after the cycle has started, select PAUSE/ CANCEL, then select the desired settings. Select and hold START (for approximately 1 second) to continue the cycle. 3-7