Kenmore HE2t User Guide - Page 85
Manual Diagnostic Test, Manual Overview Test, Program - washer manual
View all Kenmore HE2t manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
MANUAL DIAGNOSTIC TEST The washer must be empty and the control must be in the OFF state before pressing the touchpad sequence to start the test. Starting the Test Mode • Close the door. • Select any one key (except PAUSE/ CANCEL) and follow the steps below, using the same key (remember the key): Press/ hold 4 sec's. Release for 4 sec's. Press/ hold 4 sec's. Release for 4 sec's. Press/ hold 4 sec's. Release for 4 sec's. Press/ hold 4 sec's., release NOTES: • Press the same key to advance to the next failure code. • At the end of the procedure the program will loop back to the beginning. This is a continuous loop. • To cancel out of the Manual Test Mode press PAUSE/CANCEL. MANUAL OVERVIEW TEST PROGRAM Be sure to perform the Diagnostic Tests before replacing the system components. Exit Condition On completion only On key press or if overfill level is detected Control Action Door locks. Distribution system is set to Main Wash compartment. Filling with both valves. On key press or if overfill level is detected Distribution system is set to Bleach compartment. Filling only by the Hot valve. On key press or if overfill level is detected Distribution system is set to Fabric Softener compartment. Filling with both valves. On key press or if overfill level is detected On key press or completion On key press or completion On completion only On key press or completion On key press only after rpm = 0 and door is unlocked Distribution system is set to Bypass channel. Filling only by the Cold valve. For model Duet Sport HT, the Heater is on during fill until Level _wash is acti vated (80 minutes max.) Drum executes reversing movement at wash speed (10 min). Drain Pump is on (4 min). Drain Pump is on (reach Level_sud plus 10 sec). Drum rotates counter-clockwise and ramps up to maximum speed. Stop motor to 0 rpm. Door unlocks. To be Checked Door lock system Dispenser Motor Dispenser contact Cold and Hot Water Inlet Valve Overfill level Dispenser Motor Dispenser contact Cold and Hot Water Inlet Valve Overfill Level Dispenser Motor Dispenser contact Cold and Hot Water Inlet Valve Overfill Level Dispenser Motor Dispenser contact Cold Water Inlet Valve Overfill Level Heater element (if equipped) Motor Motor Control (MCU) Drain Pump Drain Pump Motor Motor Control (MCU) Motor Motor Control (MCU) Doorlock system 6-7