Kenwood DNX690HD Instruction Manual - Page 50

Return to the Top page Setting Up AV Input Setup You can set AV input parameters. 1 Touch [Menu] on any screen. 2 Touch [SETUP]. SETUP Menu screen appears. 3 Touch [Source]. AV-IN1 Name/AV-IN2 Name*2 Sets a name to be displayed when you select a system that is connected via the AV INPUT port. Default is "VIDEO". *1 T his item can be set when in STANDBY source and also the iPod is disconnected. *2 [AV-IN2 Name] becomes settable when "AV-IN2" is selected in [iPod AV Interface Use]. 4 Touch [AV-IN SETUP] in the list. AV-IN SETUP screen appears. 5 Set each item as follows. iPod AV Interface Use*1 Sets the terminal which iPod is connected. Setting values are iPod and AV-IN2. iPod (Default): S et this when an iPod is connected using KCA-iP202 connector. You can listen to audio or watch video in your iPod as iPod source. AV-IN2: Set this when an iPod is connected using KCA-iP102 connector.You can listen to audio in your iPod as iPod source. You can also listen to audio or watch video output from a AV device as AV-IN2 source. 98 AV Output Interface Setup You can select an AV source to be output at the AV OUTPUT port. Default is "VIDEO1". 1 Touch [Menu] on any screen. 2 Touch [SETUP]. SETUP Menu screen appears. 3 Touch [AV-OUT]. Return to the Top page Setting Up External Device Control Control the external device power supply. 1 Touch [EXT SW] in the Source Control screen. AV-OUT Interface screen appears. 4 Touch [2] or [3] to set [AV-OUT] to VIDEO, DISC, iPod, or OFF. EXT SW Control screen appears. NOTE • If [EXT SW] is not displayed, touch [ ]. 2 Touch the desired switch key. You can turn on or off the external device power supply. NOTE • You must connect a commercially available relay unit in order to use this function. Connect the external device to be controlled to that relay unit. • See EXT SW setup (P.90) for information on setting the power on or off specification. 99