Kenwood DNX690HD Instruction Manual - Page 53
Controlling General Audio, Equalizer Control, Operation - not loud enough
View all Kenwood DNX690HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Return to the Top page Audio Setting Up Controlling General Audio 1 Touch [Audio Control]. Subwoofer Level Adjusts the subwoofer volume. This setting is not available when subwoofer is set to "None". See Speaker setup (P.101). Bass Boost Sets the amount of bass boost among "OFF"/ "Level1"/ "Level2"/ "Level3". Loudness Turns the loudness control function on or off. If turned on, high and low tones are automatically enhanced during low volume. Settable only when zone function (P.107) is set to off. * If you have increased the volume first, then reduced the volume using the "Volume Offset", the sound generated if you suddenly switch to another source may be extremely loud. 2 Set each item as follows. Fader #/Balance # Adjust the volume balance around the touched area. [2] and [3] adjust the right and left volume balance. [5] and [∞] adjust the front and rear volume balance. Volume Offset* Finely adjust the volume of the current source to minimize the difference in volume between different sources. 104 Equalizer Control You can adjust equalizer by selecting the optimized setting for each category. If you use equalizer manually. , you can also adjust 1 Touch [Equalizer]. Return to the Top page Audio Setting Up Controlling equalizer manually This setting cannot be performed when you select [iPod] in the Equalizer screen. 1 Touch [EQ] in the Equalizer screen. 2 Touch the screen and set the Graphic Equalizer as desired. Equalizer screen appears. Operation Controlling EQ curves 1 Select EQ curve from [Natural], [Rock], [Pops], [Easy], [Top40], [Jazz], [Powerful], [iPod], and [User]. Gain level (light green boxed area) Adjust the gain level by touching the each frequency bar. Touching [2], [3], [5] and [∞] can also adjust the level. Use [2] and [3] to select a frequency, and [5] and [∞] to set the level. EQ INIT Returns to the previous level which the gain level is adjusted. Flat Tone curve becomes flat. Bass EXT (Bass Extend Settings) When turned on, the frequency lower than 62.5 Hz is set to the same gain level as 62.5 Hz. Loudness Sets the amounts of boost of low and high tones. "OFF", "Low", "High" SW Level Adjusts the subwoofer volume. This setting is not available when subwoofer is set to "None". See Speaker setup (P.101). NOTE • [iPod] is available only during iPod source. 105