Konica Minolta AccurioPress C14000 Watkiss PowerSquare 224 Offline User Manual - Page 70
Clear the Jammed Wire, See
View all Konica Minolta AccurioPress C14000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
5 - Error Conditions, Problems and Solutions - Clear a Stitch-wire Jam Clear the Jammed Wire Step 1 Action Cut the stitch-wire at position 'A', approximately 50mm (2-inches) from where the stitch-wire leaves the stitch-wire guide. Information 2 Cut the stitch-wire at position 'B', between the feed gears and the middle wire tube. 'A'. Cut stitch-wire here. 3 Pull the stitch-wire from the stitch- wire guide block. 'B'. Cut stitch-wire here. Pull stitch-wire in direction of arrow 4 Remove the middle wire tube. See Figure 32 on page 65. 5 Pull the wire from the stitch head. 6 Install the stitch-wire into the stitch See "Install the Stitch-wire into the head. Stitch Head" on page 90. 66 Watkiss PowerSquare™224 User Manual
5 - Error Conditions, Problems and Solutions - Clear a Stitch-wire Jam
66
Watkiss PowerSquare™224 User Manual
Clear the Jammed Wire
Step
Action
Information
1
Cut the stitch-wire at position ‘A’,
approximately 50mm (2-inches)
from where the stitch-wire leaves
the stitch-wire guide.
2
Cut the stitch-wire at position ‘B’,
between the feed gears and the
middle wire tube.
3
Pull the stitch-wire from the stitch-
wire guide block.
4
Remove the middle wire tube.
See Figure 32 on page 65.
5
Pull the wire from the stitch head.
6
Install the stitch-wire into the stitch
head.
See “Install the Stitch-wire into the
Stitch Head” on page 90.
‘A’.
Cut stitch-wire here.
‘B’.
Cut stitch-wire here.
Pull stitch-wire in direction of arrow